12-Gang Switch Panel With RGB And Remote Control Bluetooth App by GG Lighting
Introducing our RGB Bluetooth Switch Panel – a sleek and intuitive solution designed with user ease in mind. Effortlessly wire your accessories with bringing a new level of control and personalization to your vehicle. Experience simplicity and style seamlessly integrated into one sleek panel.
Unlock the potential of your LED Light Bars and electrical accessories with our RGB Switch Panel. Immerse yourself in the dimmable back-light display and take command with the precision of On/Off, RGB, and dimmable buttons. Explore four dynamic modes – Steady On, Momentary, Reset, and Memory – tailored to your preferences. Effortless installation on dashboard, dash panel, center console, A-pillar, and more. Experience convenience with all necessary components, hardware, and a bonus set of 50 labeling stickers included.
These rock slider steps have an interesting design and look good, unfortunately the build quality is less than expected. First, the access holes for the bolts are tight - whether they are too small or the coating makes them too small, I don’t know. I do know that it made the installation challenging. Once the bolts are seated and the nuts are tightened, the socket is wedged between the bolt head and the side of the access hole so tightly that you cannot remove the socket. I had to loosen the nut, pull the bolt partway back so I could remove the socket and then advance the bolt, wedge it in place with a flat screwdriver and tighten the nut from the other side. Especially challenging since the other side doesn’t allow room for a ratchet or closed wrench so you have to do it with the open side of a wrench. 5 out of 6 of the access holes were like this. The other worked like a charm and was super easy.
Secondly, the screws for the replaceable protector piece are easily jammed and broken. I read the instructions to take extra care to seat them properly but that doesn’t help when you cannot even remove some of them without them locking up and breaking off if you apply too much force. No matter how I seated them, I had 2 on one side and 5-7 of them on the other side that would get halfway in and lock up. I gave up and bought TEK screws and used them instead.
Thirdly, the welds were not uniform and looked amateurish. Fortunately they’re mostly hidden.
We’ll see how they perform once I get them out on the trails and rocks.
