Introducing The Weld It Yourself Cage Kit For The RZR PRO R 4 Seater! This Cage Is Built With .120 Wall DOM Main Tubes And .095" DOM Support Tubing That Can Be Either MIG or TIG Welded Without The Use Of A Specialized Fixture - Just Install The Supplied Connector Plates To The Stock Cage Locations And Piece Together The Cage On The Vehicle.
INCLUDES
Laser Cut Tube Pieces With Laser Etched Part Numbers On Each Component
1.75" OD .120 Wall DOM Tubing For Main Structure
1.75" OD & 1.50" OD .095" DOM For All Other Support Tubes
Cage Bungs & Hardware To Mount In Factory Cage Mounting Locations
REQUIRES
Welding - This Kit Can Be Welded Together Once Configured On The Vehicle
UPGRADES
Aluminum Roof - .06 Thick 2 Piece Roof W/ Small Visor Bend And Bead Rolled Joint - Complete With Weld On Tabs And 1/4" Grade 8 Hardware
Windshield Kit - Complete Bolt On Windshield Kit With .09" Powdercoated Black Aluminum Shroud With DOT Glass And Adjustable Air Vents
NOTES
Must Use A Floor Jack Under Center Of Vehicle During Installation To "level Out" The Frame Rails - Failure To Do So Will Make Aligning The Cage At The Factory Locations Difficult
This is a winter project all the weld's look good Fab work is nice. Only thing I found off so far is the the fan motor hole is a little tight for my RPM motor a little grinding will take care of that before send to powder coat desert tan. Thanks Mark
Hi Fabian, We have hundreds of these being used successfully in the field. Can you tell us how it broke? It is possible there was a manufacturing defect, but these are few and far between.
